Various automatic quantitative packaging scales are not allowed to be maintained

Release time:

2022-12-22

Automatic quantitative packaging scale is a very practical equipment for packaging products, which has been highly praised by many manufacturers since its launch. However, as it is a new product, the automatic quantitative packaging scale is not easy to solve in case of failure, especially the problem of inaccurate weighing. Once it occurs, if it is not solved immediately, the impact will be great. 1. The first case is generally out of tolerance. It is easier to solve this kind of out of tolerance. We can eliminate the causes of equipment failures, most of which are caused by improper setting of control parameters and sticking or falling off of materials in the hopper. We only need to modify the control parameters and adjust the drop (CPS) in a small range. The specific methods are as follows: The out-of-tolerance range of the scale is small, such as 40.25Kg (greater than the set 40Kg), and the drop value can be appropriately increased. The out-of-tolerance range of the scale is small, such as 39.65Kg (less than the set 40Kg), and the drop value can be appropriately reduced. 2. Generally, the drop (CPS) value is controlled at 0 2~0.5 is more suitable, for example, the set value exceeds 0 5. The out-of-tolerance should be adjusted by changing the parameters of the large feeding (SP1) instead of the drop (CPS), because the measurement accuracy will be affected by the large value of the drop (CPS). 3. The general setting range of large feeding (SP1) parameters is 8kg~12kg. The setting of fine feeding time is too short, which is easy to cause fluctuations. If the setting of fine feeding time is too long, the packaging speed will be too slow. 4. If the adjustment of drop (CPS) and large feeding (SP1) still cannot eliminate the out-of-tolerance, it can be solved by clearing and calibrating the scale